Chosen Solution I replaced my screen after it broke, and now the fans go crazy and the machine is slow, and the mouse response is sluggish (my mouse feels drunk). any thoughts? Charles This model of screen has a small thermal sensor with cable that is attached on the screen. If you turn the old screen, look at the back/top. You will see a small board that has two cables plugged in....
Chosen Solution My iMac will not boot properly. It starts up and there is a chime but the progress bar will not get more that a third of the way then it stops. It starts in recovery mode and it starts in safe boot which suggested to me that it was a software issue or a problem with the boot partition. I have replaced the internal hard drive and installed a completely new system (Yosemite) but still it will not get any further under a normal boot....
Chosen Solution I want to know if there are step by step instructions on how to remove and replace the CCFL backlight? This is what you’re looking for: http://www.lcdpart.com/files/b154ew01.pd… here is how to get to the LCD
Chosen Solution Basically, I tried to replace the digi/LCD. After replacement, I get a backlight, but the LCD is just showing black. I restored it in iTunes, and did a couple hard resets to no avail. I tested out a second LCD (which is a 4S digi/LCD) on the board in this phone without taking it fully apart and everything functioned normally. I then took the phone apart and swapped the frame on the 4S digi/LCD to make it work with the GSM phone....
Chosen Solution Hi, I recently charged my phone over night and now its dead. I’ve left it charging for about 3 days now and it wont even give a apple logo or anything on the screen. Could it be the charging ic? Or charging port? That could mean that the charging port is fryed (for some reason) and also are you sure you did not have a thunderstorm overnight?
Chosen Solution I have an iPhone 6S Plus that has a bad esn and it’s on IOS 9 and it won’t let me activate it. Can I put it into dfu mode and update it though there? Try updating through iTunes.
Chosen Solution This one has me a little stumped.. I have an iPhone 7 that I got in a job lot. It’s cosmetically “perfect” and everything appears OK. It was missing the bottom screws which told me it had been opened. The battery wasn’t connected inside. I connected the charger (via amp meter), it draws 0 mA. Just on a whim, I tested with a known good charge port assembly, same result....
Chosen Solution My daughter was using her iPhone 8 and it suddently went dark. She thinks it was around 75% on the battery and was plugged in at the time. Now it will not do anything. I have tried many different power blocks and cables, all of which work on other Apple devices. I had it sitting on a wireless charger for long an long with no joy. I have tried holding various buttons (power and vol down, power and vol up, etc....
Chosen Solution I have a iphone 8 plus that i tried to restore back to factory settings, during the restore the screen turned black with a white box with the apple logo inside it then never power back on or showed any signs of life. I have tried to hard reset it, plug into iTunes or windows and on macOS and even a new screen but nothing. I NEED HELP...
Chosen Solution So my iphone randomly bootloop when the phone is not in use This is the panic log : “panicString” : “panic(cpu 0 caller 0xfffffff023ab1c98): "i2c0::_checkBusStatus Bus is still in a bad state; last read status 00010110 int shadow 00010100 xfer 00000000 fifo 00000000 for device ad5860" This panic refers to an i2c error. Specifically i2c0. I2c is an electronics protocol which is used for inter chip communications. In the same device there may be several different i2c groups....
Chosen Solution Hi, I’ve question about face ID on iphoneX. The mic phone parts have; proximity sensor tof & flood illuminator part. Ambient light sensor part. I tried replaced as new one of mic phone parts whole of it and I just changed original one proximity sensor tof & flood illuminator part to new one. Not Ambient light sensor part. Is that OK? or I have to be change Ambient light sensor part also?...
Chosen Solution Hello there, My iPod Touch 3 is having White Screen of Death issues. The iPod first had a white screen of death in 2016. In 2018 I was able to temporarily fix it by using the Power+Home button, but in 2019 it started having the issues again and it hasn’t worked since. I have tried Power+Home button again, I have tried restoring the iPod, and even replacing the display....
Chosen Solution I have done a lot of glass repairs on s4 but managed to cut the digitizer ribbon in the top left corner on 2 of them, is it possible to buy the digitizer film only? if so where as I can’t find anything on eBay. Thanks Hi, i know what you mean! I refurbish broken lcd’s too and im having the same issue trying to find the digitizer film for a galaxy 3 lcd....
Chosen Solution Hello everyone. I apologize for my English in advance. Here’s the deal: I bought a used PS4 with an HDMI port torn off from PCB and some tracks and pads being destroyed underneath it. When turning on the console I can hear it beeps, it’s starting to blink blue, the fan and hard drive start spinning. Also, here’s some more symptoms that I noticed: -usb’s don’t have power (i’m not sure if it should be there when the console goes on)....
Chosen Solution This picture shows the connector line in an iPhone 5 Device Can someone tell us why, because I thought it was the antenna. Thank You I think you have a different phone here your image is not clear enough to identify the phone or the wire. See if you can take a better image (higher resolution) showing the full phone as well as one that focuses on the area here....
Chosen Solution so i replaced the battery on my charge 2 plus with the one listed on ifixit websiteJBL Charge 2 Plus Battery Replacement . when i plug it int to charge the battery it just flashes on the first battery light forever. so i reset the charge 2 by holding the phone and volume up button at the same time and now it turns on when plugged in and makes a really loud but deep beeping sound over and over even if its connect to my phone....
Chosen Solution I set a PIN lock on my phone while it was charging at work and now I can’t disable the PIN and change it back to SWIPE to unlock it or disable the lock screen at all. I’ve gone into my Security settings and cleared the credentials but I’m still unable to fix it. Ya, that happened to me. I erased credentials, which works for some people but not me....
Chosen Solution I followed your repair guide to replace the battery. I assemble the phone in reverse of the repair guide, but when I switched on, the touch screen could not scroll. I tried the soft and hard reset and all suggested methods, but still while the opening screen is on and the phone is connected to wifi etc, still touch sreen is dead. Any help pls`? Take apart your device again and see if there is any damage to the digitizer connection flex cable....
Chosen Solution can anyone assist in giving guides how to set the timing There is a timing mark, and a timing plate. You need to find these on your car. (The timing mark is on the flywheel.) And you need to get a piece of chalk and put a chalk mark on the timing mark, and at the correct position on the timing plate. The chalk marks will make things easier to see....
Chosen Solution There are wide vertical bands of color across the screen of my Sony KDL-40VL160 TV, mostly pink in color. Update (09/28/2018) Can you open these? @amdmd that could be a T-con board, Main board or panel issue. Try your onscreen TV menu and let us know if that still displays properly. Ultimately you will have to remove teh back of the TV and take a look at all the boards and check for obvious damage like domed,leaking capacitors etc....
