Posts

Chosen Solution I was drinking water and it spilled on laptop and tap top got stuck after drying and turned off so how do I turn back on Hi, What is the make and model number of your laptop? The impurities in the water causes corrosion and provides circuit paths for the electricity which were not in the laptop’s operating design and could damage the components. The corrosion starts immediately and is ongoing until it is completely cleaned away First do not try to charge or to turn on your laptop and then remove the battery as soon as possible from the laptop to minimize any further damage....

Chosen Solution Ice maker quit making ice. I have changed the water filter and not getting any water still. Does it take a while to begin working after changing the filter? Check your solenoid or float and ball assembly, however yours is equipped. If solenoid equipped, is it getting voltage? Is it a type that may be cleaned and checked by you? If float and ball, check and clean.

Chosen Solution About 2 or 3 months ago I ordered a replacement battery from IFixit for my iPhone 6s Plus. It has worked fine until recently all of a sudden. My problem is best described as once the battery level drops to around 60%-30% (it varies), my phone slows down to a crawl and is practically unusable despite the battery percent stating the battery isn’t about to die. There’s a 1 in 5 chance that if I restart my phone the percentage drops to around 10%, as if the percent meter isn’t calibrated....

Chosen Solution One normal day I turned on my Macbook and my screen was completely dark, as if it had given problems in the backlight. Today after some time with it turned off, I turned on HDMI and it worked on a second monitor When I unplugged the HDMI, the Macbook screen turned on again, but if I increase the brightness to a certain extent, the screen turns black again. What can it be?...

Chosen Solution Hi. iPhone6plus screen cracked and was left unused for months. I got new screen form ifixit, but after change phone does not “start". It power on and with a flashlight I can see a apple logo on the screen coming and going. So infinite loop with no backlight on the screen. Visual check says that cables and connectors are ok. Can a dead battery do this? Logic board? Thank you....

Chosen Solution My Face ID in iPhone 11 damaged when my phone screen broken , where can I found Face ID part , please iPhone 11 Transfer ambient light sensor and flood illuminator from original flex to new flex Your front camera and earpiece speaker/proximity sensor assembly cable is paired to the motherboard you can’t change the parts because you will lose face Id because the parts will not be paired....

Chosen Solution I’m trying to find someone who can help me answer a tough question. I am replacing the back housing on my iPhone 11. I purchased a back housing and behind the tiny hole next to the camera lenses is supposed to be some sort of cover that possibly has to do with the mic? My new housing has nothing here so you can see right through the hole to the outside....

Chosen Solution Sorry for my bad english. I took my phone to a bad repair service to change the battery, and since then, my phone only charges after few trys of plugging it and unplugging it. I tried different cables and wall adapters but I always face the same problem. When plugged to a computer it shows up and stay connected ( I think the charging port is not defected ) and it electrocutes me when I touch it....

Chosen Solution iPhone 6 locked after screen replacement. Message appears to connect to iTunes. When connecting to iTunes message on iTunes appears to unlock the iPhone with code. An endless loop. Maybe an Apple lock when detecting an unoriginal screen? Don’t know. Please help. Thanks Do the following ONLY IF ALL the following conditions are met: You are sure that the device does not have Find my iPhone enabled, or you or the owner knows the Apple ID and password....

Chosen Solution Hi I recently bought an cracked iPhone 7, in hopes of resseling it, note it was my first time fixing an iPhone, I bought the replacement screen, and put the bluetooth home button, the first time i encountered the problem was when I finished it all, it started turning off and then on until it drains a battery which happens really fast, it usually happens on 20% and 50%, I tought it was due to battery which was replacement one even though it was on 100% health, so i replaced it with the original one, and when it is about to turn off it becomes very hot under the rear camera, I cleaned all the connectors with PCB cleaner with awarenes of not damaging it, I also have to menition the backplate on battery and the lcd connectors has only one screw holding the backplate, also the display backplate had one bruised screw which I had to cut off and bruise that backplate side, but the display is fine....

Chosen Solution my ipod stays on the red battery screen. Its been plugged in and won’t charge. when I plug the cable in the phone obviously detects the cable because it turns the screen on to show the dead battery but that little lightning connection icon doesn’t show up to indicate that its charging. I looked in the port and nothing appears to be broken or corroded. Any one know whats wrong with it?...

Chosen Solution my ipod turns off on me when i use it. when i want to charge it, it just turns on and off and it doesn’t charge. i been having that problem for a while now and i got mad c cause i dont know what is wrong with the ipod. any dropping or fluid damages in the past ? did you try to charge it with the computer or with the ac adapter ?...

Chosen Solution Would a rear end out of a 2002 Chevy suburban fit into a 2003 Chevy Tahoe, both are four-wheel-drive Would a rear end out of a 2002 Chevy suburban fit into a 2003 Chevy Tahoe, both are four-wheel-drive I am not 100% sure but most likely producers tend to keep the same frame for a couple of yours until they make changes to the body style in something like the 2000s this is especially correct I would definitely do some more digging if I were you but most likely yes unless they changed the body style of the car during those years

Chosen Solution I don’t see any guides on the site, so I’m guessing not, but would appreciate knowing definitively. The RAM is part of the logic board. You’d have to buy a logic board replacement that is a model with more RAM

Chosen Solution I want to try and replace my A10 chip but I don’t feel like getting a new phone. Is there a way to replace it with a higher one? No chance its soldered in.

Chosen Solution Charged all night then went into app all OK got out was gonna go to Note pad phone shut off. Turned it on again it said fully charged then again it shut completely off and won’t turn back on try to charge and It makes a whirring sound. Please help if you can phone only 2 years old. Barron Crimson, Try and do a hard reset in case it is a corrupt App/software/etc....

Chosen Solution Recently I had my phone fixed and a few days ago, when my phone was dead I dropped it…It lead to my phone’s left side of the screen and top part to be loose and unattached. I don’t know if I should attempt to put it back into place as it is quite risky.What should I do? I would take it back to wherever you had it fixed to have them address it....

Chosen Solution Charging Jack appears to be BROKEN! I can charge my battery on my friends phone. He has the same Alcatel one touch, purchased a few yrs ago. When I try to charge there is no connection, no blue light. NOTHING! Can I repair the jack? Phone is with Public Mobile and having a !&&* of a time getting help! Unless you know it is the jack, I would go for the battery first....

Chosen Solution In a fit of rage and stupidity ,I slammed my laptop closed and now it is inoperable. I have a windows Vista factory out of the box recovery program but it will not recover. It will load first disc and second disc but 32% through the recovery it has an error and shuts laptop down. Do I need a replacement laptop along with anger management ? Lol Hi Ebert, While the machine is running, place your ear next to the machine and listen for any signs of hard drive failure....

Chosen Solution I just got started with the installation of windows 10 to my Macbook Air and when I reached the place to select a partition then I deleted the partition and made a new partition And after the completion of windows installation I can’t head back to the Mac designed OS. Its like that with the partition deletion process the Mac OS is gone. Any way how I can reinstall it somehow get back to the Mac system Id not want windows just screw windows I want my own lovely Mac OS Any way?...