Chosen Solution ipad mini (wifi ) screen is locked and cant able to unlock -sliding menu is not working.Please support here to solve this Did you try restarting Press and hold the power button and then use the slide off. If you can’t do that that tells me your touch logic is damaged and you either need a new screen assembly or the logic board has damage.
Chosen Solution So I took the landline apart and I found a small piece of metal that looks to be broken off I doubt very much if I could get a replacement for that part so I’m wondering if I should try to Sauter a small piece of metal to the broken part or would it hold? These things need new batteries every couple of years: Panasonic KX-TGA600M Battery Replacement
Chosen Solution Hello, I’m getting missbrew and “water circuit priming” message once in the wile. Sometimes machine can not start, getting prime cycle looped. After cycle machine in empty pre grind coffe mode - problem goes away for a wile… steps been taking : thorogh clean up brew unit and nozzles, descaling …still have this issue. Please help Max Hello, you have to open the machine and clean the flowmeter and the tubes…....
Chosen Solution My audio jack is compromising my speakers. Everytime I play something over the speakers they fuzz out on one side. I think the jack is loose. How do I replace it? It’s pretty straight forward once you get the bottom cover off following this guide: MacBook Pro 15" Touch Bar 2017 Lower Case Replacement Locate the jack you’ll find a metal plate covering the connectors connector on the back edge of the logic board....
Chosen Solution I replaced my battery with the one from iFixit and put it on charge from 10%, but now it’s been more than 5 hours and the phone it stuck on 99%. what do I do? The battery health is showing 100% This is not much of a problem but just to test it you can put your old battery back into the phone to test if the battery is facility or some other component, im guessing the charge controller on the battery has stopped working defaulting to 100 (99) percent....
Chosen Solution Any tips on Removal of the old one. And install of the new one ? andrew chuka III make sure you can get the car high enough like, 2 to 3 feet. You will have to drop the subframe, that is why you need that clearance. Don’t over-tighten any of the bolts and do not loose any of the locking plate for your subframe. You’ll need a special tool to release the hydraulic lines and a tie-rod tool : Remover, Tie-Rod End 211-001 (TOOL-3290-D) Disconnect Tool, Spring Lock Coupling 310-041 (T90T-9550-C) “4....
Chosen Solution I’m looking for a good quality, reliable iPad 6 digitizer glass with home button already installed. Please let me know, thank you very much! Hi, I’m not too familiar with the retail side of parts, only wholesell. But I think ifixit has a good warranty policy. Note: If you want to keep the touch ID function you will need to transfer the original home button to the new digitizer....
Chosen Solution Hey guys So my iPad Pro 12,9” 1. Gen stopped working today. It does not turn on or react to anything at all. I have tried everything, including a restore in DFU mode. It used to work perfectly until yesterday, no signs of defect or anything, no liquid damage, nothing. Is there anything I can do before handing it in to the Apple Store and pay around 400€ for a replacement?...
Chosen Solution Hi Jessa, Hope everything is going well for you. I am in trouble with an iPhone 4S and your thoughts would be very helpful to me. The battery connector was separated from the logic board among with the two central pads and part of it’s track. My question is: What is the most appropriate solution for this case? I have thought two different solutions as follow: 1- Make a jumper with a small copper wire....
Chosen Solution On my iphone 5, the proximity sensor does not work. Auto Brightness works without a problem, but at a call or something else, the sensor does not work. I have changed the sensor 2 times, what else could it be? After you replaced it did you soft reset the device? A lot of times it won’t register until that has been done. If you have and no luck, make sure you transfer that little white film (black screen only) to the new screen....
Chosen Solution Hi, I cracked my screen on my iPhone 6 Plus a few days ago and immediate bought a replacement screen and replaced yesterday. Since replacing my battery has become very poor, I would say when using the phone it drops 1% around every minute and whilst in standby (overnight) it dropped around 20%. I have turned everything off (location services, bluetooth, notifactions, mail etc) and even enable battery saving too....
Chosen Solution My iphone 6 16gb iOS 8.4.1 , is shutting off and not turning back on only when i press lock button + home button , please what is the issue and the solution ? Your on an old ios Update and it should cure the problem
Chosen Solution hello . I try to charge my iphone 7 plus using usb power meter to see how amps its take. But when i plug my charger, it’s only take 0.00 amps. What is the problem ? battery or motherboard ? It’s hard to tell without looking at the phone myself but you should start by replacing the charge port or at least cleaning it. If you have a pair of fine-tipped tweezers or even a toothpick you should be able to poke around inside and scrape out any dirt and debris....
Chosen Solution Hey guys! I have the weirdest situation with iPhone and I am trying to find out is it only me or another people too. So, long story short. Situation #1. A customer brought in an iPhone XS for a back glass replacement. I took a phone apart and changed a glass. When I put a phone together the touch screen stopped working. I disconnected the original screen and connected a GSX copy and it started to work....
Chosen Solution Yes, I know it might say Sony BDP-S3700 but the one that I have is Sony BDP-S1700 and it reads the DVD discs fine and without any problems but it just makes awful somewhat silent clicking noise while playing. I don’t have any Blu-Rays and I use the player to watch burned DVD’s. The DVDs are fine no scratches nor dusts and they’re brand new. Also the player is pretty new....
Chosen Solution Air play CDs but not DVDs why @maf2017 that sounds like trouble with the laser assembly. You have two different lasers, one for CD and one for DVD. Obviously the DVD laser is no longer properly working. You could try to get a commercial laser lens cleaning kit and see if that makes a difference. If not you will have to take your DVD player apart and see if you can get to the laser assembly for cleaning and /or possible replacement....
Chosen Solution Me and my brother were going through our grandmas storage building and found her old iMac. I pulled it out and I have been trying to get it to start but it won’t turn on. Any ideas would be helpful because I’ve always wanted to look around on an old computer and now I have the chance. I have it plugged in and the original keyboard and mouse that they got....
Chosen Solution I Install apk play store is not working how can I fix it If you did a factory reboot and formatted the system partition you erased your account information. Go to settings, accounts, manage accounts and add your account information. If you backed up to google’s server or another place you should be able to restore whatever you backed up, otherwise you’ll be stuck installing everything manually. I may be misunderstanding your question though....
Chosen Solution Since I have the 2 phones can I just switch the motherboard and sim to the other stylo since it would be a lot easier than removing both screens to replace the broken one. The second phone is on another carrier and I cannot get that company to unlock to port over. Will this work or Will I have to change the screens joshua_moss since it is looked by the company switching the switch the motherboard and sim to the other stylo ill not work....
Chosen Solution I have the motherboard I just need the phone Roderick Allen not sure what it is that you are trying to do. If you have a motherboard and want to place it in a phone, I suggest a damaged phone from any of the online auction sites or even craigslist etc.
